VES-1012 Hardware Installation Guide
2.4.1
Attaching the Mounting Brackets to the VES-1012
Position a mounting bracket on one side of the VES-1012, lining up the four screw holes on the bracket
Step 1.
with the screw holes on the side of the unit (see the figure shown next).
Using a #2 Philips screwdriver, install the M3 flat head screws that came with the brackets through the
Step 2.
mounting bracket holes into the VES-1012.
Repeat Step 1 and Step 2 to install the second mounting bracket on the other side of the unit.
Step 3.
Figure 2-1 Attaching the Mounting Brackets to the VES-1012
You may now mount the VES-1012 on a rack. Proceed to the next section.
2.4.2
Mounting the VES-1012 on a Rack
Position a mounting bracket (that is already attached to the VES-1012) on one side of the rack, lining up
Step 1.
the two screw holes on the bracket with the screw holes on the side of the rack (see the figure shown
next).
2-2
Failure to use the proper screws may damage the unit.
Failure to use the proper screws may damage the unit.
Hardware Installation