Hyundai Santa Fe Sport Owner's Manual page 324

Voice Recognition Mode
Using Voice Recognition
Starting Voice Recognition
Shortly press the button on the
steering wheel remote controller. Say
a command.
If prompt feedback is in [ON], then
the system will say "Please say a
command after the beep (BEEP)"
• If prompt feedback is in [ON]
mode, then the system will only
say "(BEEP)"
• To change Prompt Feedback
[On]/[Off], go to [SETUP]
[System] [Prompt Feedback]
For proper recognition, say the com-
mand after the voice instruction and
beep tone.
✽ ✽ NOTICE
Contact List Best Practices
1) Do not store single-name entries
(e.g., "Bob", "Mom", "Kim",
etc.). Instead, always use full
names (including first and last
names) for all contacts (e.g., use
"Jacob Stevenson" instead of
"Dad").
2) Do not use abbreviations (i.e., use
"Lieutenant" instead of "Lt." or
"Sergeant" instead of "Sgt.").
3) Do not use acronyms (i.e., use
"County Finance Department"
instead of "CFD").
4) Do not use special characters
(e.g., "@", "hyphen -", "asterisk
*", "ampersand &").
5) If a name is not recognized from
the contact list, change it to a
more descriptive name (e.g., use
"Grandpa Joseph" instead of "Pa
Joe").
Features of your vehicle
Skipping Prompt Messages
While prompt message is being stat-
ed Shortly press the
the steering remote controller.
The prompt message is immediately
ended and the beep tone will sound.
After the "Beep", say the voice com-
mand.
Re-starting Voice Recognition
While system waits for a command
Shortly press the button on the
steering remote controller.
The command wait state is immedi-
ately ended and the beep tone will
sound. After the "Beep", say the
voice command.
button on
4 227