Hyundai Santa Fe Sport Owner's Manual page 171

Features of your vehicle
5. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
6. Firmly press and release the
"learn" or "smart" button. (The
name and color of the button vary
by manufacturer). There are 30
seconds to initiate step 7.
7. Return to the vehicle and firmly
press, hold for 2 seconds and
release the programmed
HomeLink ® button. Repeat the
"press/hold/release" sequence a
second time, and, depending on
the brand of the garage door
opener (or other rolling code
equipped device), repeat this
sequence a third time to complete
the programming process.
HomeLink ® should now activate your
rolling code equipped device.
4 74
Gate operator & Canadian
programming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink ®
Control System button (note steps 2
through 3 in the Programming por-
tion of this document) while you
press and re-press ("cycle") your
handheld transmitter every two sec-
onds until the frequency signal has
been learned. The indicator light will
flash slowly and then rapidly after
several seconds upon successful
training.
Operating HomeLink ®
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
Reprogramming a single
HomeLink ® button
To program a device to HomeLink
using a HomeLink
trained, follow these steps:
Wireless
1.Press and
HomeLink ®
release the button.
2.The indicator light will begin to flash
after 20 seconds. Without releasing
the HomeLink
with "Programming" step 2.
For questions or comments, contact
HomeLink ® at www.homelink.com or
1-800-355-3515.
button.
®
®
® button previously
hold the desired
button. DO NOT
® button, proceed