Hyundai Santa Fe Sport Owner's Manual page 164

Gate operator & Canadian pro-
gramming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink ®
Control System button (note steps 2
through 4 in the
Programming portion of this docu-
ment) while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
Operating HomeLink
®
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
Reprogramming a single
HomeLink ® button
To program a new device to a previ-
ously trained HomeLink
low these steps:
Wireless
1. Press and
HomeLink ® button. Do NOT release
Standard
until step 4 has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter 1
to 3 inches away from the
HomeLink ®
3. Press and hold the handheld
transmitter button. The HomeLink
indicator light will flash, first slowly
and then rapidly.
4. When the indicator light begins to
flash rapidly, release both buttons.
® button.
5. Press and hold the just-trained
HomeLink ®
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
Erasing HomeLink
Individual buttons cannot be erased.
However, to erase all three pro-
® button, fol- grammed buttons:
1. Press and hold the two outer
hold the desired
2. Release both buttons. Do not hold
The Integrated HomeLink
Control System is now in the training
surface.
(learn) mode and can be pro-
grammed at any time following the
® appropriate steps in the Programming
sections above.
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
button and observe
Features of your vehicle
® buttons
HomeLink ® buttons until the indi-
cator light begins to flash-after 20
seconds.
for longer than 30 seconds.
® Wireless
4 67