Sony TAV-L1 Service Manual page 38

TAV-L1
Sensor status:
Bit1: EMER DW
0: Undetected
1: Detected
Bit2: STOP DW
0: Low (sensor open)
1: High (sensor shielded)
Bit3: DROP DW
0: Low (sensor open)
1: High (sensor shielded)
Bit4: DROP UP
0: Low (sensor open)
1: High (sensor shielded)
Bit5: STOP UP
0: Low (sensor open)
1: High (sensor shielded)
Bit6: EMER UP
0: Undetected
1: Detected
Bit7: FG SPEED ERROR
0: Undetected
1: Detected
Bit8: FG COUNTER ERROR
0: Undetected
1: Detected
• 1_PWMXX
Note: This code has to convert to decimal.
This code means motor duty (motor speed) at error detection.
If value is more than 128, it means speed-adjusting worked and
(value – 128) is the duty.
• 1__FGXXXX
Left 2numbers : FG counter, place of thousands/hundreds
Right 2numbers : FG counter, place of tens/one
Note: These 2 code has to convert to binary.
This code means FG counter at error detection.
This has 2meanings as follows:
Bit7 of sensor status
0
1
• 1TOUTXX
This code means timer remained.
If value is 0, it means operation-timeout occurred.
If you want to know how many msec remain, (value × 512) will be
the answer.
38
FG code means
Counter between each sensor
Counter every 500 msec
Typical Example
• DROP DW broken
Code
HIST01 FG counter error
JCPB121 Normally open
Motor driver status 93 → 10010011
SENS9398
Over current permitted
Open direction
Motor Drive
Sensor status 98 → 10011000
FG counter error detected
STOP UP shielded
DROP DW shielded
DROP DW open
Duty 188 → (188 – 128) = 60 % with speed adjust
PWMBC
1C → 28
FG1C58
58 → 88
means FG was counted 2888 pulse
13 → 19
TOUT13
remains 19 × 512 = 9728 msec remains
FG counter over at open normal operation and DROP DW was
undetected, this code means "DROP DW seems to be broken" or
"Belt was slipped".
LIFT DEMO MODE
Procedure:
1. Press the [POWER] button to turn the power on.
2. Touch and press three buttons of
for five seconds.
3. The message "DEMO ON" is displayed on the fluorescent
indicator tube and the lift demonstration mode turns on, then
following operation is repeated.
Note: When the lift mode is set to the lock, it doesn't operate.
Opening for three minutes
Lift up
Closing for ten seconds
Lift down
4. To release from this mode, press or touch three buttons in the
same manner as step 2 or execute COLD RESET.
Note: Even when power supply is turned off, this mode isn't released.
Meaning
, and simultaneously
N x . H