Configuring load sharing modes for link aggregation groups
You can configure global or group-specific load sharing mode. A link aggregation group preferentially
uses the group-specific load sharing mode. If no group-specific load sharing mode is available, the
group uses the global load sharing mode.
Configuring the global link-aggregation load sharing mode
Step
1.
Enter system view.
2.
Configure the global
link-aggregation load
sharing mode.
In system view, the switch supports the following load sharing modes and combinations:
Source IP address.
•
Destination IP address.
•
Source MAC address.
•
Destination MAC address.
•
•
Source IP address and destination IP address.
Source IP address and source port.
•
Destination IP address and destination port.
•
Source IP address, source port, destination IP address, and destination port.
•
Any combination of ingress port, source MAC address, and destination MAC address.
•
Configuring group-specific load sharing mode
Step
1.
Enter system view.
2.
Enter Layer 2 aggregate
interface view.
3.
Configure the load sharing
mode for the aggregation
group.
In Layer 2 aggregate interface view, the switch supports the following load sharing modes and
combinations:
Source IP address.
•
Destination IP address.
•
•
Source MAC address.
Command
system-view
link-aggregation global load-sharing
mode { destination-ip | destination-mac
| destination-port | ingress-port |
source-ip | source-mac | source-port } *
Command
system-view
interface bridge-aggregation
interface-number
link-aggregation load-sharing mode
{ { destination-ip | destination-mac |
mpls-label1 | mpls-label2 | source-ip
| source-mac } * | flexible }
51
Remarks
N/A
By default, the system
automatically chooses
link-aggregation load sharing
mode based on packet types.
Remarks
N/A
N/A
By default, the load sharing mode
is the same as the global load
sharing mode.