HP FlexFabric 12900 Series Configuration Manual page 144

Step
7. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
8. Configure the uplink port as a
promiscuous or trunk
promiscuous port of the
specified VLANs.
9. Return to system view.
10. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
11. Assign the downlink port to
secondary VLANs.
12. Return to system view.
13. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
14. Configure the downlink port
as a host or trunk secondary
port.
15. Enter primary VLAN view.
Command
interface interface-type
interface-number
•
Configure the uplink port as a
promiscuous port of the
specified VLAN:
port private-vlan vlan-id
promiscuous
•
Configure the uplink port as a
trunk promiscuous port of the
specified VLANs:
port private-vlan vlan-id-list
trunk promiscuous
quit
interface interface-type
interface-number
a. Set the link type of the
port:
port link-type { access |
hybrid | trunk }
b. Assign the access port to
the specified VLAN:
port access vlan vlan-id
c. Assign the trunk port to the
specified VLANs:
port trunk permit vlan
{ vlan-id-list | all }
d. Assign the hybrid port to
the specified VLANs:
port hybrid vlan
vlan-id-list { tagged |
untagged }
quit
interface interface-type
interface-number
•
Configure the downlink port as
a host port:
port private-vlan host
•
Configure the downlink port as
a trunk secondary port:
port private-vlan vlan-id-list
trunk secondary
vlan vlan-id
136
Remarks
N/A
By default, a port is not a
promiscuous or trunk promiscuous
port of any VLAN.
N/A
N/A
Select substep b, c, or d depending
on the port link type.
N/A
N/A
By default, a port is not a host or
trunk secondary port.
N/A