Fiber Optic Ethernet Ports; Sfp Transceivers - Siemens RUGGEDCOM RSG2100 Installation Manual

Chapter 3
Communication Ports
Section 3.2

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
1
Figure 19: MTRJ Port
1. Tx Connector 2. Rx Connector
1
Figure 21: SC Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
Section 3.3

SFP Transceivers

The RUGGEDCOM RSG2100 features two Small Form-Factor Pluggable (SFP) transceiver sockets, which are
compatible with a wide array of SFP transceivers available from Siemens.
The following SFP transceivers are compatible with the RUGGEDCOM RSG2100. For more information, including
installation/removal instructions and ordering information, refer to the
[https://support.industry.siemens.com/cs/ca/en/view/109482309] .
IMPORTANT!
Only use SFP transceivers approved by Siemens for RUGGEDCOM products. Siemens accepts no liability
as a result of performance issues related in whole or in part to third-party components.
SFP Transceiver
RUGGEDCOM SFP1112-1
RUGGEDCOM SFP1122-1SX
RUGGEDCOM SFP1122-1SX2
RUGGEDCOM SFP1132-1LX10
24
2
Figure 20: LC Port
1. Tx Connector 2. Rx Connector
2
Figure 22: ST Port
1. Tx Connector 2. Rx Connector
Order Code
6GK6000-8CG01-0AA0
6GK6000-8FG51-0AA0
6GK6000-8FE58-0AA0
6GK6000-8FG52-0AA0
1
1
Section 4.5, "Fiber Optic Ethernet Port
RUGGEDCOM SFP Transceiver Catalog
Speed
a
Mode
(Mbit/s)
b
10/100/1000 CAT-5e
Copper
1000 MM
1000 MM
1000 SM
RUGGEDCOM RSG2100
Installation Guide
2
2
Nominal Distance (km)
0.1
0.5
2
10
Fiber Optic Ethernet Ports