Siemens RUGGEDCOM RSG2100 Installation Manual page 11

RUGGEDCOM RSG2100
Installation Guide
Display Mode Indicator LEDs
Mode button
Alarm Indicator LED
Power Module Indicator LEDs
RS-232 Console Port
Description
The display mode indicator LEDs indicate the current display mode for the port status
indicator LEDs (i.e. Status, Duplex or Speed).
The Mode button sets the display mode for the port status indicator LEDs (i.e. Status, Duplex
or Speed). It can also be used to reset the device if held for 5 seconds.
The alarm indicator LED illuminates when an alarm condition exists.
The power module indicator LEDs indicate the status of the power modules.
• Green – The power supply is supplying power
• Red – Power supply failure
• Off – No power supply is installed
The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to Section 2.8, "Connecting to the
Introduction
Device".
Chapter 1
3