Table of Contents
Advertisement
Chapter 7 Basic M-CMTS Data Specific Operation
4
Select the Allowable Ingress Ports which receives the flows from the CMTS.
The correct GbE port (independent mode) or port pair (port-pair mode) will have
its GbE port physical address (independent mode) or Video/Data IP address
(port-pair mode) under the System/IP Network web view configured to match
the eQAM IP address in the CMTS.
5
Enter the Destination UDP Port for the input stream to be mapped out to the
relevant RF Gateway 1 carrier. The Destination UDP Port must match the udp-
port of the corresponding rf-channel in the CMTS.
Notes:
–
–
6
Click Apply.
7
Click Save.
Connecting to DTI Server
The RF Gateway 1 chassis provides redundant RJ-45 connections for connecting to
DTI server devices. These connectors are located along the bottom row of RJ-45
connectors on the rear panel of the RF Gateway 1 chassis.
To Connect To DTI Server
1
Locate the DTI ports on the rear panel of the RF Gateway 1 chassis.
2
Connect the RF Gateway 1 to the timing server network using CAT5 cable.
To Configure DTI
1
Navigate to the System page.
116
Session ID will automatically set to "N/A" when Stream Type is MPEG.
For a given ingress port pair, the UDP port or session ID must be unique.
78-4025112-01 Rev H0
Advertisement
Table of Contents
