Table of Contents
Advertisement
4
In the Backup SNTP Server IP Address field, enter the IP address in xx.xx.xx.xx
format.
5
In the SNTP Mode field, select "Unicast" (Multicast is not supported).
6
In the Time Zone field, select the correct time zone depending on current location.
7
The Synchronization Interval parameter specifies the interval at which the RF
Gateway 1 resynchronizes the system clock and RTC to the network time. Set the
SNTP Synchronization rate in minutes. The default is 1440 minutes or 24 hours.
8
The Synchronization Timeout parameter specifies how long the RF Gateway waits
for the network time server to respond. Set the timeout in seconds.
9
Click Apply.
10 Click Synchronize Now to force a network synchronization. This sets the
system's time and RTC.
11 Click Save.
Result: On the next system reboot, the system time is displayed in periodic
intervals based on the Synchronization Interval setting.
Parameters
The following table explains the Clock Configuration parameters.
Parameter
Current Time
New Time
Synchronize with Server
Main SNTP Server IP
Address
Backup SNTP Server IP
Address
SNTP Mode
Time Zone (Offset from
UTC)
Synchronization Interval
Synchronization Timeout
Last Synchronized Time
Additional Configuration
The RF Gateway 1 provides several additional configuration parameters applicable
as needed.
78-4025112-01 Rev H0
Description
System's current time.
System's new time.
Specifies the source of time synchronization, network time server
or on-board real-time clock.
IP address of the Main SNTP server.
IP address of the Backup SNTP server.
Always set to Unicast.
Used to configure an offset from UTC time.
Specifies the interval at which the system resynchronizes the
system clock and RTC to the network time.
Specifies how long the RF Gateway waits for the network time
server to respond.
Indicates when the last successful network synchronization
occurred.
Clock Configuration
51
Advertisement
Table of Contents
