Connecting To Dc Power - Cisco 1100 Series Hardware Installation Manual

Install and Connect the Router

Connecting to DC Power

Warning
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes. Statement 1074
Warning To reduce risk of electric shock, when installing or replacing the unit, the ground connection must always be
made first and disconnected last. Statement 1046
Warning To reduce risk of electric shock, before performing any of the following procedures, ensure that power is
removed from the system. Statement 1003
Caution
The two negative and two positive inputs are not intended for redundant connection to two independent sources
of supply. The two negative and two positive input terminals are intended to increase current-carrying capacity
by paralleling conductors.
If the two negative and two positive inputs are used, the negative inputs must be connected to the same source
and the positive inputs must be connected to the same source.
Hardware Installation Guide for the Cisco 1100 Terminal Gateway
Connecting to DC Power
29