Checking The Throttle Override System (T.o.r.s.) - Yamaha VK10A Owner's Manual

Periodic maintenance and adjustment
1. Locknut
2. Throttle cable free play adjusting bolt
3. Throttle cable free play
Throttle cable free play:
2.0–3.0 mm (0.08–0.12 in)
5. Tighten the locknut.
6. Close the shroud.
ESU11863
Checking the throttle override
system (T.O.R.S.)
EWS00352
WARNING
When checking the T.O.R.S., take precau-
tions to avoid snowmobile movement
which could cause an accident:
Make sure that the throttle lever moves
G
smoothly with the engine off before
checking the T.O.R.S.
Make sure that the parking brake is ap-
G
plied.
Do not rev the engine to the point that
G
the clutch engages.
44
Check the T.O.R.S. for proper operation.
1. Start the engine.
TIP
Refer to the "Starting the engine" section on
page 29.
2. Hold the pivot point of the throttle lever
away from the throttle switch by putting
your thumb (above) and forefinger (be-
low) between the throttle lever pivot and
the engine stop switch housing.
While holding the pivot point as described
above, squeeze the throttle lever gradu-
ally.