Yamaha VK10A Owner's Manual page 27

1. Rear storage area
2. Rear carrier
Maximum load limit:
Rear storage area:
5 kg (11 lb)
Rear carrier:
20 kg (44 lb)
EWS00140
WARNING
Do not use the rear carrier to lift the snow-
mobile. The snowmobile could fall, which
could result in severe injury or death.
To remove the passenger seat and backrest
1. Open the rider seat. (See "Storage com-
partment" for details.)
2. Remove the passenger seat bolts, slide
the passenger seat and backrest slightly
rearward, and then lift them straight up to
remove them.
1. Passenger seat bolt
2. Passenger seat and backrest
Control functions
3. Install the passenger seat bolts, and then
tighten them to the specified torque.
NOTICE: When using the rear storage
area, do not load any cargo that is too
large for it. In addition, cargo must not
project from the edges of the rear stor-
age area.
[ECS00211]
Passenger seat bolt tightening torque:
47.5 Nm (4.75 m·kgf, 34 ft·lbf)
To install the passenger seat and backrest
1. Open the rider seat. (See "Storage com-
partment" for details.)
2. Remove the passenger seat bolts, insert
the hooks on the bottom of the passenger
seat and backrest into the slots in the rear
storage area, and then slide the seat and
backrest forward. NOTICE: Make sure
that the wire harness is not pinched
when installing the passenger seat
and backrest.
[ECS00231]
21