Table of Contents
Advertisement
6. Mechanical adjustment
[3]
[1]
[5]
[7]
[4]
40
[2]
[6]
A07TF3C508DA
Service Manual
Field Service Ver. 2.0 May 2008
5. Loosen four screws [1].
6. Adjust the 1st stopper assembly [2]
by moving the front side of the
assembly to right and left by referring
to the markings [3], and then tighten
the four screws [1].
• When the skew pattern is [4], move
the front side of the 1st stopper
assembly [2] to the left [5].
• When the skew pattern is [6], move
the front side of the 1st stopper
assembly [2] to the right [7].
7. Replace the Z folding/conveyance
unit, and then perform the Z-folding
printing operation and check to see if
the skew of the 1st folding is within
the standard value.
8. Repeat steps 5 to 7 until the stan-
dard value can be obtained.
Y107910-0
Advertisement
Table of Contents
