Hilti TE 7-A Operating Instructions Manual page 8

2.4 Grips
Vibration-absorbing, pivotable side handle with depth gauge
Vibration-absorbing grip
2.5 Protective features
Mechanical slip clutch
Electronic overload protection
2.6 Additional electronic features of the power tool
The power tool is equipped with electronic overload protection. The power tool switches off automatically in the event
of overloading. When the control switch is released and then pressed again, the power tool immediately regains full
power.
In addition, the temperature of the power tool's electronics is monitored to ensure extra-long life. Spindle speed
is reduced automatically by the electronic control unit in the event of the maximum permissible temperature being
exceeded. The drive spindle then rotates only very slowly even when the control switch is fully depressed. The
electronic control unit allows full spindle speed to be reached again as soon as the temperature has dropped to within
the permissible range.
2.7 Lubrication
Oil lubrication
2.8 Items supplied as standard
1 Power tool
1 TE‑C CLICK chuck
1 Side handle with depth gauge
1 Operating instructions
1 Hilti toolbox or cardboard box
1 Cleaning cloth
1 Grease
2.9 Additional items required for operating the tool
One B 36/2.4 NiCd battery with C 7/36‑ACS charger or one B 36/3.3 Li‑Ion battery with C4⁄36‑90 or C4⁄36‑350
charger, or one B 36/3.9 Li‑Ion battery with C 4/36‑ACS charger.
2.10 Li‑ion battery charge status
LEDs light constantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
-
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation.
Indication is given (LED 1 blinks) only when the battery is fully discharged or when it is too hot (temperature above
80°C).
LEDs blink
-
-
-
-
LED 1
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
en
3