Stretch Stitch Feed Balance - Janome 7330 Servicing Manual

STRETCH STITCH FEED BALANCE

When a stretch stitch pattern is sewn with the feed balancing dial position set at the standard setting mark "
stitch pattern should look like the one marked with a "
If forward and backward feeding is unbalanced (A.B or A,B), adjust as follows.
ADJUSTMENT PROCEDURE:
1. Turn the power switch on and select the stitch pattern "
2. Set the slit of the feed balancing dial to the standard setting mark "
3. Put a piece of paper under the presser foot and lower it.
Turning the handwheel toward you, and check the needle mark at "A" and "B".
4. Remove the setscrew (A) and base cover.
5. If A>B, turn the adjusting screw counterclockwise "C".
6. When A<B, turn the adjusting screw clockwise "D".
7. Attach the cap.
Standard setting
mark
Indication line
MECHANICAL ADJUSTMENT
Feed balancing dial
Adjusting screw
" (A=B) in the diagram below.
".
" on the front cover.
F
18
Base cover
Setscrew (A)
G
7330
", the