HP proliant ML110 gen9 Maintenance And Service Manual page 42

CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 24).
4.
If installed, remove the PCI air baffle (on page 25).
5.
Remove the system air baffle (on page 26).
6.
CAUTION: When connecting or disconnecting the cache module cable, the connectors on
the cache module and cable are susceptible to damage. Avoid excessive force and use
caution to avoid damage to these connectors.
If necessary for easier access to the cache module connector and/or removal of an air scoop,
7.
remove the storage controller from the PCI riser cage or from the system board.
If the cache module is covered by an air scoop, remove the air scoop.
8.
Disconnect the cache module backup power cable from the cache module.
9.
Removal and replacement procedures 42