Remove the system air baffle.
6.
Non-hot-plug drive cage
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 24).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
4.
Remove the access panel (on page 24).
5.
Remove the front bezel (on page 25).
6.
If installed, remove the PCI air baffle (on page 25).
7.
Remove the system air baffle (on page 26).
8.
Disconnect all existing drive cables.
9.
Removal and replacement procedures 27