Punch - Ricoh AFICIO MP 2851 Operating Instructions Manual

3. Other Print Operations
• If the paper contains sheets of differing lengths but same widths (like A4
17" and 8
• When feeding paper from the bypass tray.
• When staples have run out and Auto Continue is set (Printing will continue without stapling after
the message has been displayed).
• When only 1 page is printed.
• When staples have run out.
3
• When the stapling is canceled, "BD: Staple has been cancelled." appears.
• If Staple or Shift Collate is selected with the optional Finisher SR790, Finisher SR3000, or SR3050
installed, the paper will be output to the finisher shift tray irrespective of the setting.
• When printing on letterhead, stapling may not be at the specified position.
• If you cannot make staple settings even with Finisher SR790, Finisher SR3000, or SR3050 installed,
options may not be set correctly in the printer driver. Correct option settings in the printer driver. For
details, see the printer driver Help.
• When the finisher is being used for another function's job (for example, a copy job), printing will start
after that job ends.
• Be sure to set paper size and orientation in the printer driver when stapling.
• When duplex printing is selected, adjust staple positions to the binding orientation.
• Depending on the application you are using, print settings may not be stored and the printed result
may not be as expected.
• When setting Staple in the printer driver settings, make sure that a collate option is not selected in the
print settings of the application. If a collate option is selected in the application, printing will not be
as intended.
• When using the optional Finisher SR3050 following paper sizes can be stapled using the Mixed Size
mode.
• A3 and A4
• B4 and B5
• 11" 17"

Punch

With the optional Finisher SR3000 and Punch Unit installed, holes can be punched into printed outputs.
104
1
/ " 11" ), and the paper sizes are mixed on a single job.
2
1
and 8 / " 11"
2
and A3 , 11"