Securing The Refrigerator - Dometic RMDX21 Installation Manual

Installing the refrigerator
6.7

Securing the refrigerator

!
CAUTION!
Only screw through the receptacles provided, otherwise foamed
components, including cables, can be damaged.
I
NOTE
Attach the side walls or the attached strips so that the screws are
tight, even when under increased loads (while driving).
➤ Move the refrigerator into its final location.
➤ Fasten the four screws (fig. k 1, page 8) through the four plastic
washers in the sides of the refrigerator, and further into the wall.
➤ Put the caps (fig. k 2, page 8) onto the screw heads.
6.8 Replacing the door panel
A
NOTICE! Beware of damage
The door panel must not be replaced when the refrigerator is
upright.
Only decorative trim with frame: The door panel has the following
dimensions (fig. l, page 8):
Freezer compartment door: A
Refrigerator door: B
Removing the door panel from framed door model
Proceed as follows (fig. m, page 9):
➤ Remove the door trim carefully. It is only clipped in and held in place by
small hooks.
➤ Pull the old panel away from the door trim still installed.
➤ Push the old panel upwards as far as the stop.
➤ Pull the old panel out of the door.
28
RMDX21, RMDX25
EN