Configuring Vtp V3 Pruning - Cisco Nexus 6000 Series Configuration Manual

Configuring VTP V3 Pruning

Step 12
Step 13
Step 14
Step 15
Step 16
This example shows how to configure VTP in transparent mode for the device:
switch# configure terminal
switch(config)# feature vtp
switch(config)# vtp domain accounting
switch(config)# vtp version 2
switch(config)# vtp mode transparent
switch(config)# exit
switch#
Configuring VTP V3 Pruning
Follow the steps given below to configure VTP V3 Pruning.
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
138
Command or Action
switch# show vtp counters
switch# show vtp interface
switch# show vtp password
switch# show vtp devices [conflict]
Example:
Device# show vtp devices
Gathering information from the
domain, please wait.
VTP Database Conf switch ID
Primary Server Revision
Name
lict
------------ ---- --------------
-------------- ----------
----------------------
VLAN Yes 00b0.8e50.d000
000c.0412.6300 12354
main.cisco.com
MST No 00b0.8e50.d000
0004.AB45.6000 24
main.cisco.com
VLAN Yes
000c.0412.6300=000c.0412.6300 67
qwerty.cisco.com
switch# copy running-config
startup-config
Purpose
(Optional)
Displays information about VTP advertisement
statistics on the device.
(Optional)
Displays the list of VTP-enabled interfaces.
(Optional)
Displays the password for the management VTP
domain.
(Optional)
This is a VTP version 3 command that displays
information about neighbor switches. The information
is not learned from the summary packet used for
regular VTP packets. This command sends out a
separate packet to collect information regarding
neighbor switches running VTP version 3.
System
(Optional)
Copies the running configuration to the startup
configuration.
Configuring VTP V3