Understanding Bpdu Filtering - Cisco Nexus 6000 Series Configuration Manual

Configuring STP Extensions
interface signals an invalid configuration, such as the connection of an unauthorized host or switch. BPDU
Guard, when enabled globally, shuts down all spanning tree edge ports when they receive a BPDU.
On the edge trunk interface level, if the remote side of the disabled VLAN is configured as an access port
Note
then the BPDUs will be ignored.
BPDU Guard provides a secure response to invalid configurations, because you must manually put the LAN
interface back in service after an invalid configuration.
Note When enabled globally, BPDU Guard applies to all operational spanning tree edge interfaces.

Understanding BPDU Filtering

You can use BPDU Filtering to prevent the switch from sending or even receiving BPDUs on specified ports.
When configured globally, BPDU Filtering applies to all operational spanning tree edge ports. You should
connect edge ports only to hosts, which typically drop BPDUs. If an operational spanning tree edge port
receives a BPDU, it immediately returns to a normal spanning tree port type and moves through the regular
transitions. In that case, BPDU Filtering is disabled on this port, and spanning tree resumes sending BPDUs
on this port.
In addition, you can configure BPDU Filtering by the individual interface. When you explicitly configure
BPDU Filtering on a port, that port does not send any BPDUs and drops all BPDUs that it receives. You can
effectively override the global BPDU Filtering setting on individual ports by configuring the specific interface.
This BPDU Filtering command on the interface applies to the entire interface, whether the interface is trunking
or not.
Caution Use care when configuring BPDU Filtering per interface. If you explicitly configuring BPDU Filtering
on a port that is not connected to a host, it can result in bridging loops because the port ignores any BPDU
that it receives and goes to forwarding.
If the port configuration is not set to default BPDU Filtering, the edge configuration does not affect BPDU
Filtering. The following table lists all the BPDU Filtering combinations.
Table 7: BPDU Filtering Configurations
BPDU Filtering Per Port
Configuration
Default
BPDU Filtering Global
Configuration
Enabled
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
Information About STP Extensions
STP Edge Port BPDU Filtering State
Configuration
Enabled EnabledThe port
transmits at least 10
BPDUs. If this port
receives any BPDUs, the
port returns to the
spanning tree normal port
state and BPDU Filtering
is disabled.
95