Reassembling The Playback/Recording Head - JVC RV-NB10BJ Service Manual

3.3.6 Reassembling the playback/recording head

(See Figs.10 to 12)
(1) Reassemble the head mount.
a) To become direction of the left side, direction lever of
the head mount assembly is maintained by the hand.
(See Fig.11.)
b) Reassemble the playback/recording head from the
front of the head mount assembly to the position as
shown Fig.10, Fig11, and Fig.12. (m', n', p' and q', r'
are set to the hole of n and p and ditches of m, q and
r and thrusting out the head mount assembly is built
in.
(2) Fix the reversing azimuth screw. (See Fig.12.)
(3) Set the spring from the bottom side of the playback/record-
ing head. (See Fig.12.)
(4) Attach the flexible wire to the section k of the chassis base
assembly. (See Fig.12.)
1-24 (No.MB519)
m'
q'
r'
Fig.10
m
p
n
Fig.11
Playback/recording head
Reversing azimuth screw
Spring
Flexible
wire
k
CN31
Head amplifier & mechanism control board
Fig.12
n'
p'
Detection lever
Head mount
Assembly
q
r
Head mount assembly
Chassis base assembly