Device; Hdd; Ptz - Samsung SDR-B73303 User Manual

DVR Menu

Device

HDD

Go to "Main Menu" ; "Device" ; "HDD" to enter into the interface.
When HDD is connected, the system will automatically detect if the HDD is normal or not; if the HDD needs to be formatted,
select the HDD and format it. If the system detects the HDD is normal, the HDD status will be shown as "Normal".
• no.: Number of HDD connected to system.
• status: It shows the current status of the HDD. It will be available only when
the HDD is "Normal".
• free/total space: Remaining or total space of the HDD
• free time: Remaining time for the HDD recording according to current
setting for "Resolution", "Encoding Rate" and "Frame Rate" of image.
• Auto-overwrite: When set to ENABLE and the hard drive is full, the DVR will
overwrite the oldest files on the hard drive. When set to DISABLE and the
hard drive is full, the DVR will stop recording.
• format HDD: Format HDD for the first use.
Recording can only be performed when the HDD is in "Normal" state.
`
M

ptz

Go to "Main Menu" ; "Device" ; "PTZ" to enter into the interface.
Select a PTZ channel and set PTZ protocol(Pelco-D, Pelco-P ,COAX),
Baudrate (1200, 2400, 4800, 9600), DataBit（8, 7, 6, 5（, StopBit (1, 2), Parity
(None, Odd, Even Mark Space), Address and Cruise.
Parameter setting for above channels must be the same as that of PTZ so that
PTZ can be controlled. The protocol, baudrate and PTZ address must be set.
Doesn't support preset point setup and cruise of PTZ speed dome cameras through
`
M
coax communication.
28_ DVR Menu