How To Use Channel-1 Temperature/Humidity Alarm - Oregon Scientific RMR132HG User Manual

To clear the memory:
• Press and hold MEMORY for 2-seconds.
If you press MEMORY now, the maximum and minimum
temperatures will have the same values as the current ones until
different readings are recorded.
HOW TO USE CHANNEL-1
TEMPERATURE/HUMIDITY ALARM
Upper and lower temperature and humidity limits for channel-1
can be set so that an alarm activates when the limits are exceeded.
The high and low temperature and humidity displays are selected
by sequentially pressing HI/LO.
The high-low displays are as follows:
Sequence Respective Display
Pressing HI/LO once Enters HI temperature display
Pressing HI/LO twice Enters HI humidity display
Pressing HI/LO third time Enters LO temperature display
Pressing HI/LO fourth time Enters LO humidity display
To set a high or low temperature or humidity alarm:
1. Press HI/LO, channel-1 will be displayed.
9
RMR132HG_M_EN_R01
2. Press L to set the temperature or humidity limit. Each press
will increase increments by 1 degree or percentage. Press and
hold the button for a rapid-scrolling sequence by increments
of 5.
Note:
The temperature range is from -50°C (-58°F) to +70°C (158°F).
If this is the first time you set the limits, the lower limit will start
from -50°C (-58°F) and the upper limit +70°C (158°F). Otherwise,
the reading will start from the temperature last selected.
The humidity range is from 2% to 98%.
If this is the first time you set the limits, the lower limit will start
from 2% and the upper limit 98% Otherwise, the reading will start
from the humidity last selected.
3. Repeat the steps to set the upper humidity setting and the lower
temperature and humidity settings.
4. When finished, press HI/LO to set another limit or wait 16-
seconds and the unit will automatically return to the normal
display. The respective HI, LO or both indicators will light up
to signify the status of the alarm.
If in another channel-1 other than channel one is selected, when the
alarm activates the display will switch to channel-1 and the display
will flash. If left untouched, the alarm will activate
[HI/LO], [L], [ON/OFF]
Pr ess IN/CHANNEL , MEMORY,
to momentarily stop the alarm. The alarm will activate again if the
value continues exceeds the set limit.
9
8/13/04, 12:30 PM
for 1-minute.
(TEMP % RH AL)