Transmission Collision; Calendar Clock Display Modes; Disconnected Signals - Oregon Scientific RMR132HG User Manual

Note: If a second limit is passed while an alarm is active, the first
alarm will complete its 1-minute cycle and the alarm will continue
to activate for a second minute cycle to indicate that a second limit
has been surpassed.
To disable an alarm:
1. Enter the setting mode by pressing HI/LO.
2. Then, press AL ON/OFF.
The alarm has been disabled and will not sound at the previously
set limit.
To disable a sounding alarm:
[HI/LO], [L], [ON/OFF]
• Press IN/CHANNEL, MEMORY,
(TEMP % RH AL)
the alarm sound will stop.

DISCONNECTED SIGNALS

If without obvious reasons the display for a particular channel goes
blank, press IN/CHANNEL & MEMORY to enforce an
immediate search.
If that fails, check:
1. The remote unit of that channel is still in place.
2. The batteries of both the remote unit and main unit. Replace as
necessary.
10
RMR132HG_M_EN_R01
Note that when the temperature falls below freezing point, the
batteries of outdoor units will freeze, lowering their voltage supply
and the effective range.
3. The transmission is within range and path is clear of obstacles
and interference. Shorten the distance when necessary.

TRANSMISSION COLLISION

Signals from other household devices, such as door bells, home
security systems and entry controls, may interfere with those of
this product and cause temporarily reception failure. This is normal
and does not affect the general performance of the product. The
transmission and reception of temperature readings will resume
,
once the interference recedes.

CALENDAR CLOCK DISPLAY MODES

The RMR132HG supports four display modes in the sequence of:
MODE 1. Local Time
Hour, Minute Second
Day, Month
10
8/13/04, 12:30 PM