Setting The Clock; Setting The Alarm Time - Grundig Ocean Boy 70 Instructions Manual

:
1 2 0 0
:
1 6 2 5
:
2 1 4 9
:
5 5 0
:
6 2 0
:
2 1 5 1
20
SETTINGS

Setting the clock

When you first use the device, you first have to set the clock.
1 With the device switched off, keep pressing »MODE« until the time
flashes in the display.
Note:
If you do not press any button within 5 seconds, the device will quit set-up
mode. Any altered settings will be stored.
Press »HOUR –« briefly to set the hours step-by-step or hold it down to
2
run through the hours quickly.
»MIN +
Press « briefly to set the minutes step-by-step or hold it down to
3
run through the minutes quickly.
Note:
When the minute display changes from »59« to »00«, this does not
affect the hour display.
Press »MODE« to confirm the setting.
4
– Display: the current time.

Setting the alarm time

Press »ON/OFF« to switch off the device.
1
– Display: the current time.
2 Press »MODE« briefly.
– Display: the alarm time most recently set, »
Hold down »MODE« until the alarm time flashes in the display.
3
Note:
If you do not press any button within 5 seconds, the device will quit set-up
mode. Any altered settings will be stored.
Press »HOUR –« briefly to set the hours step-by-step or hold it down to
4
run through the hours quickly.
Press » MIN + « briefly to set the minutes step-by-step or hold it down to
5
run through the minutes quickly.
Note:
When the minute display changes from »59« to »00«, this does not
affect the hour display.
Press »MODE« to confirm the setting.
6
– Display: the set alarm time, »
– After a short time, the display changes to the current time.
______________________________________________
« or »e« flash.
« or »e« flash.