Table of Contents
Advertisement
Using the Main Menu
SYSTEM
Open the System menu to configure the following options:
• HDD
• CLOCK
• VIDEO STANDARD
• LANGUAGE
HDD
Format a new hard disk and configure internal
hard disk settings.
Figure 12.0 HDD menu
To initialize the hard disk:
ATTENTION: Initializing (formatting)
the HDD erases all data on the hard
disk. This step cannot be undone.
1. From the System menu, select HDD and
press the
button.
2. From the HDD menu, press the
to open the HDD Initialize screen.
3. Select YES and press the
[Select NO and press the
cancel, or the
formats the hard disk, erasing all recorded
video data. System settings and
configurations remain intact. After a few
moments the system returns to the HDD
menu.
38
button
button.
button to
button.] The system
• REMOTE CONTROL ID
• KEY ECHO
• ADVANCED SETUP
• FIRMWARE UPDATE
4. Press the
button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SAVE AND EXIT
to save your settings.
NOTE: If you replace the internal 2.5" hard
disk, you should always initialize the new
disk. If you do not initialize (format) the new
hard disk, it may not be properly read by the
system.
Advertisement
Table of Contents
