Table of Contents
Advertisement
Figure 25.6 Motion Area Setup
3. Click Clear All to remove motion detection
from all cells. Grid cells should be green.
4. Click the radio button to select the size of
cursor—1x1, 3x3, or 5x5.
5. Select cells in the grid to enable with
motion detection. Enabled cells should
turn from green to clear.
6. Click OK to save your grid configuration or
click Cancel to exit without saving.
7. To save your settings to your DVR, click
Update to DVR.
Sensor Input
Configure the sensors connected to the
system. Depending on your model, you can
connect from 4 to 16 sensors.
Figure 25.7 Sensor Input options
To configure sensor input:
1. Click the drop-down menu for each
respective channel and select one of the
following:
• NORMAL OPEN:
normal times.
• NORMAL CLOSE:
normal times.
No sensors are connected to
• NOT USED:
the system (default for all channels)
2. To save your settings to your DVR, click
Update to DVR.
Remote Setup
The sensor is open at
The senor is closed at
93
Advertisement
Table of Contents
