Installing An Internal Tape Drive; Replacing The Pci Slot Cover; Removing The Filler Panel - HP StorageWorks D2D User Manual

Figure 16 Replacing the PCI slot cover

Installing an internal tape drive

Read this section if your are installing an internal tape drive. If you are connecting an external tape drive,
go to "Replacing the access panel and
WARNING!
To avoid personal injury or damage to the server or tape drive, ensure that the server is disconnected
from the mains power supply while you install the drive.
CAUTION:
Static electricity can damage electronic components. Always wear an antistatic wriststrap if one is
available. If not, after you have disconnected power from the server and removed the cover, touch a bare
metal part of the chassis. Similarly, touch a bare metal part of the drive before installing it.
1.
Access the removable media cage (1) and remove the filler panel (2).
Figure 17 Removing the filler panel
2. Mounting screws and shims are provided in the Mounting Hardware pack, which is supplied with
the tape drive. Locate the pack of short, cylindrical-headed screws and shims.
bezel" on page 35.
D2D Backup System
33