Hot-Plug Drive Leds; Fibre Channel Card Leds - HP StoreOnce G3 Installation And Configuration Manual

2. LAN activity status LED indicator

Hot-plug drive LEDs

The status of hot-plug hard drives installed in the server is indicated by the drive activity LED indicator
located on the front panel of the server.
Figure 14 Drive LEDs
1. Disk Online LED
2. Disk beacon LED

Fibre Channel card LEDs

If you have a Fibre Channel version of the HP StoreOnce Backup system, there are three LEDs
adjacent to each FC port.
Table 1 FC card LEDs
Yellow LED
Off
On
Flashing
Alternately flashing
Off
Off
Off
Off
On
Flashing
Green LED Amber LED
Off Off
On On
Flashing Flashing
Alternately flashing Alternately flashing
Off On
Off Flashing
On Off
Flashing Off
Off Off
Off Off
Flashing green: Ongoing network data activity.
Off: No network data activity or no connection.
Steady green: Online, no activity
Flashing green: Ongoing disk activity
Steady amber: Disk has failed
Flashing amber: Predictive disk failure
Off: The disk is not a part of RAID
Steady blue: identifies a specific disk within the unit. The
LED can be beaconed on and off from the StoreOnce
Management Console.
Activity
Power Off (OK)
Power on before or after software initialization.
Awaiting HBA software initialization.
Power on after software initialization. Link not
initialized.
software fault (OK)
Connected at: 2 (HP D2D4300 Series only) or
1 (all other FC systems) Gb/s
Activity at 2 (HP D2D4300 Series only) or 1
(all other FC systems) Gb/s (OK)
Connected at 4 (HP D2D4300 Series only) or
2 (all other FC systems) Gb/s
Activity at 4 (HP D2D4300 Series only) or 2
(all other FC systems) Gb/s (OK)
Connected at 8 (HP D2D4300 Series only) or
4 (all other FC systems) Gb/s
Activity at 8 (HP D2D4300 Series only) or 4
(all other FC systems) Gb/s
Hot-plug drive LEDs 47