Toshiba PORTEGE M400 Maintenance Manual page 387

4.19 MDC
4. Turn up two points of insulator and disconnect the MDC cable from the connector
CN4100 on the system board.
Insulator
Installing the MDC
The following describes the procedure for installing the MDC. (See Figure 4-35 and 4-36.)
1. Connect the MDC cable to the connector CN4100 on the system board and wrap it
with insulator.
2. Connect the MDC cable to the connector on the MDC.
3. Install the MDC to the connector CN3010 on the system board and secure it with the
following screws.
• M2.0×4.0B
PORTEGE M400 Maintenance Manual (960-541)
MDC cable
CN4100
Figure 4-36 Removing the modem cable
BIND screw
4 Replacement Procedures
×2
[CONFIDENTIAL] 4-55