Ricoh 3800C Installation Manual page 3

Fasten the 4-bin mailbox using two screws and the
provided screwdriver.
Be sure to return the provided screwdriver to its original
position on the inside of the front cover.
Close the upper left cover.
If the duplex unit is installed, proceed to step .
.
Install the external tray into the printer. Hook the external
tray the printer's slits, and then lower the tray toward you.
If the duplex unit is installed, return the duplex reversal
unit to its original position. Lift slowly, until you hear a
click.
Remove the adhesive tape from the cable of the 4-bin
mailbox.
ZHXH400J
Check the cable of the 4-bin mailbox is in position, as
shown.
If it is not, change its position in the direction of ( ) c ( ).
Connect the cable from the 4-bin mailbox to the lower
connector on the back of the printer.
ZDJP096J
ZDJP098J
ZDJP994J
ZDJP091J
ZHXH260J