Advanced Routing; Static Routing List - TP-Link TL-WR841N User Manual

Chapter4
Access Control Rule Management
(?)
Enable Internet Access Control
DefauH FiHer Policy
®
Allow the packetsspecified
by any
enabled access co ntrol policy to pass through the Ro uter
Deny the packets specified by any enabled access co ntrol policy to pass through the Route r
Save
Configure
Done!
Now only the specific host(s) can visit the target(s) within the
scheduled time period.
4. 11. Advanced Routing
Static Routing is a form ofrouting that is configured manually by a networkadministrator
or a user by adding entries into a routing table. The manually-configured routing
information guides the router in forwarding data packets to the specific destination.
4. 11. 1. Static Routing List
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Advanced Routing
>
Static Routing.
~ To add static routing entries:
1. Click Add New.
Add
or
Modify a Static Route Entry
Destination Network:
Subnet Mask:
Default Gateway:
Status:
1
Enabled
"1
Save
Back
2. Enter the following information.
Destination Network - The Destination Network is the address of the network
or host that you want to assign to a static route.
Subnet Mask - The Subnet Mask determines which portion of an IP address is
the network portion, and which portion is the host portion.
Default Gateway - This is the IP address of the default gateway device that
allows the contact between the router and the network or host.
50