Spray Mist; Shot Of Steam - Sunbeam GCSBBS5806 Owner's Manual

SPRAY MIST

• The Spray Mist feature is a powerful water spray mist that dampens the
fabric to help remove wrinkles from heavy fabrics and to set creases.
• Press the Spray Mist button firmly to start the spray.
DUAL SHOT OF STEAM
This feature allows you to use Shot of Steam
vertically, as the next two sections describe.

SHOT OF STEAM

• The Shot of Steam
penetration of stubborn wrinkles. The Shot of Steam
used with dry or steam ironing provided it has at least a ¼ tank of
water and the Temperature Control Dial is set within the steam band.
• Allow the iron to heat for approximately two minutes.
• Press the Shot of Steam
• Press the Shot of Steam
clean the unit.
• The Shot of Steam
feature can be used continuously with just a short pause between shots.
The Shot of Steam
horizontal position just above the fabric being ironed.
• If the Water Reservoir runs dry, unplug the Iron and refill with water. The
Iron may be filled with water while it is hot. Note: It may be necessary
to re-prime the pump before using the Shot of Steam
®
®
feature provides an extra burst of steam for deep
®
Button several times to prime the pump.
®
Button another three to four times in order to
®
feature is now ready for use. The Shot of Steam
®
feature is most effective with the Iron held in a
®
-E7-
while ironing horizontally or
®
feature can be
®
feature again.
®
®