Steam & Dry Feature; Spray Mist/Variable Steam Feature; Auto-Off Feature - Sunbeam 3956 Instruction Manual

Steam & Dry Feature
When using as a steam iron, press down or slide the button (depending on the model of your iron)
to the STEAM position. If using the iron as a dry iron, or filling the iron with water for steam
ironing, press down or slide the button to the DRY/FILL position.
Spray Mist Feature
(Some Mode/s
Press spray button to spray water in a fine mist to dampen fabric for removal of tough wrinkles.
Variable Steam Feature
When steam ironing, move the variable steam slide to one of the steam areas:
GENTLE steam for lightweight and delicate fabrics such as polyester and silk,
at low temperatures.
FULL steam for medium weight fabrics such as wools and cotton blends.
ULTRA steam for heavy fabrics such as cotton and linen at high temperatures.
Smart" Auto-Off Feature
Safety
When the iron is plugged into a 120 volt, AC electrical outlet, the steady red signal light signals
the iron is on or is ready to be turned on. If the iron is left standing on the heel rest for 15 minutes,
the iron will stop heating. The signal light flashes to indicate auto shut-off and will continue
flashing until the iron is either restarted or unplugged.
If the iron is left in the ironing position, the iron switches to the Auto-Off mode in 30 seconds.
Again, the signal light flashes to indicate auto shut-off and will continue flashing until the iron
is either restarted or unplugged.
TO RESTART IRON: To restart the iron after it has shut itself off, select DRY/FILL; then move the
iron back and forth in the ironing position until the signal light changes from flashing to steady.
Make sure the slide control is set at the desired temperature and allow 3 minutes for the soleplate
to get to the selected temperature before selecting steam level.
CAUTION: 00 NOT USE THE AUTO SHUT-OFF FEATURE AS A SUBSTITUTE FOR TURNING OFF
AND UNPLUGGING THE IRON WHEN NOT IN USE.
On/y)
(Some Models Only)
(Some Models Only)
D R Y
FILL