Spray Mist - Sunbeam STEAM MASTER 4049 Instruction Manual

Retractable cord iron
Table of Contents

Advertisement

Available languages

Available languages

SHOT OF STEAM
• The SHOT OF STEAM
wrinkles. The SHOT OF STEAM
tank is at least 1/4 full of water and the temperature dial is set within the steam band.
• Place the iron on top of the wrinkle and press the SHOT OF STEAM
would like an extra burst of steam. THE SHOT OF STEAM
with just a short pause between shots.
VERTICAL STEAM (Select models only)
• The vertical steam feature allows your iron to function as a garment steamer.
TIP: When using the vertical steam on clothing, hang the clothing on a clothes hanger for best
results. Hanging curtains and drapes may also be steamed.
To Use VERTICAL STEAM:
1. Make sure that the iron has heated up (2 minutes).
2. Hold the iron in a vertical position, with the iron close to but not touching the fabric you want
to steam.
3. With your other hand, pull the fabric tight.
4. Press the SHOT OF STEAM
across the wrinkled area.
WARNING: To prevent the risk of burns, keep your hand away from the area being steamed.
DO NOT steam garments while wearing them; this may result in injuries.

SPRAY MIST

Feature
®
(Some Models Only)
• Use the SPRAY MIST
• Press the gray SPRAY MIST
MOTION SMART
• When the iron is plugged into 120 volt AC electrical outlet, the
steady red light signals that the iron is plugged in and is ready to
be turned on.
• If the iron is left on the heel rest unmoved the iron will stop heating in
15 minutes. The light on the handle will blink to indicate the iron has automatically shut off and
will continue blinking until the iron is restarted or unplugged.
• If the iron is left unmoved in the ironing position or accidentally tipped over, the iron will
stop heating in 30 seconds. Again, the light on the handle will blink to indicate the iron has
automatically shut off and will continue blinking until the iron is restarted or unplugged.
NOTE: If the temperature dial is turned to the OFF position, the light will continue blinking and
then go off.
• To restart the iron, move the iron back and forth. Allow the iron to heat and continue ironing
as normal.
Feature
®
feature provides an extra burst of steam for deep penetration of stubborn
®
feature can be used with dry or steam ironing provided the
®
button in approximately 3-second intervals as you move the iron
®
feature to dampen fabrics with stubborn wrinkles.
®
button firmly to produce spray.
®
Auto Off Feature (Some Models Only)
®
feature can be used continuously
®
7
button each time you
®

Advertisement

Table of Contents
loading

Table of Contents