Functional Operation; Powering Up The System; Displaying The Identification (Id) Code; Selecting A Satellite Channel - Audiovox SIRIUS SRSIR-001 Owner's Manual

Functional Operation

Functional operation of the system is controlled by the buttons on the
SCU; i.e., the sequence in which they are pressed and the length of time
button activation occurs.

POWERING UP THE SYSTEM

After the system has been properly installed it can be powered on in the
following manner:
1. Apply power to the vehicle's radio.
2. Apply power to the Satellite System Control Unit SCU by
momentarily pressing (2 seconds) the Power On/Off button (
the SIRIUS® logo will appear and then slowly fade out.
3. Tune the vehicle's radio to a selected FM frequency between
88.1MHz and 89.3MHz. If you are not sure which frequency to select,
use the radio's SEEK, SCAN or TUNE function to scroll through the
frequencies until the satellite signal is played through the speakers.
NOTE: The default FM frequency is 88.5MHz.
4. Enter this frequency into memory using one of the preset buttons on the
vehicle's radio; make note of the FM band and preset number.
Figure 4. The SIRIUS ® Logo Appears-and-Satellite Program is
Loaded
5. After the correct frequency is identified and entered into the radio's memory,
the SCU will display the preview channel (CH184) if the SIRIUS® service
is being activated for the first time (see DISPLAYING THE IDENTIFICA
TION (ID) CODE). If the SIRIUS® service was previously activated, the
SCU will return to the SIRIUS® channel used when the system was last
turned off.

DISPLAYING THE IDENTIFICATION (ID) CODE

Once the system is installed you must first subscribe to the SIRIUS®
Radio service to activate the system. The SIRIUS® Radio service uses
an ID code to identify your radio. This code is needed to subscribe to
SIRIUS® Radio, and if needed, is also used to report any problems
should there be any in the future.
To display the radio ID code, proceed as follows:
);
1. To display the ID Code enter SFT+0+SFT
2. Make a note of your radio ID Nunber
3. Contact SIRIUS ® Radio on the web, or by phone, to
subscribe to the service.
Figure 5. SIRIUS ® ID Code

SELECTING A SATELLITE CHANNEL

Selecting a satellite channels can be accomplished in four ways;
1. Scrolling channel-by-channel
2. Selecting a group or category of channels
3. Scrolling and Selecting a Preset channel
4. Direct channel access.
The following subsections describe the procedure for each of the op-
tions.
NOTE: If the SIRIUS® signal reception appears to be noisy or contains
audible background static, try switch to another FM frequency.
Refer to Direct FM Frequency Selection for details on how to select
another FM frequency.
5
128-6374
5 of 12