Table of Contents
Advertisement
GMRS-2000
Instruction Manual
7) Mode (Function) key sequence
! 1'st press -- CTCSS
! 2'nd press – Tx power Hi Low select
! 3'rd press -- Dual watch channel select
! 4'th press –- Dual watch ctcss channel select
! 5'th press –- Beep ON/OFF
! 6'th press -- Roger beep ON/OFF
! 7'th press -– Ringer type select
2
INSTALLATION
Your GMRS-2000 is designed for use with five "AA" size rechargeable battery (supplied with radio) or
Alkaline Batteries(not supplied).When rechargeable battery cell is installed, please charge the batteries for
at least 12 hours before use.
New rechargeable batteries should be fully charged before use. While rechargeable battery charge, the
radio must be turned off during charging.
Warning
Do not use wall charger with Alkaline batteries. The radio will be damaged.
1) Installation of the batteries
! Ensure the On/Off switch on the radio is to set Off position.
! Hold the radio and battery cover with the back facing you.
! Press down the 'battery cover latch' to release the battery cover.
! Install five "AA" size Alkaline batteries or rechargeable batteries.
Note : Carefully observe the polarity of the batteries before installing.
!
Install the battery cover into the radio until the cover latch click into place.
2) Antenna
The antenna is connected to the radio. It is detachable.
Please do not attempt to transmit without an antenna,
the radio will damage.
3
Basic Operation
1) On/Off & Volume control Switch
! Radio ON : Rotate the switch clockwise until you here a 'click'. All indicators will appear
momentarily on the LCD and you will hear short beep sound.
! Radio Off : Rotate the switch counter clockwise until all indicators disappear on the LCD.
!
Volume setting : Rotate On/Off Volume switch to mid position or adjust level that is most
comfortable for you.
2) Selecting the Channel and tone code(CTCSS)
GMRS-2000 has a tone code system
!
38 CTCSS Code ( indicated by
01-03-09
- 5 -
CTC icon on the LCD )
Advertisement
Table of Contents
