Audiovox SRSIR001FM - Sirius® Satellite Radio Tuner Installation Manual
Sirius satellite digital audio control and receiver system
Hide thumbs
Also See for SRSIR001FM - Sirius® Satellite Radio Tuner:
- Owner's manual (12 pages) ,
- Owner's manual (12 pages) ,
- Owner's manual (13 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Audiovox SRSIR001FM - Sirius® Satellite Radio Tuner
Summary of Contents for Audiovox SRSIR001FM - Sirius® Satellite Radio Tuner
-
Page 1: Installation Manual
SATELLITE DIGITAL AUDIO ® RECEIVER SYSTEM MODELS SRSIR-001, SRSIR-001FM and MODEL SRSIR-001FMR INSTALLATION MANUAL For Customer Service Visit Our Website At .audiovox.com Product Information, Photos, FAQ’s Owner’s Manuals... - Page 2 It is important that the installer reads and understands all of the installation procedures for each of the components to be installed, either supplied with the Audiovox Electronics SIRIUS Satellite Digital Audio Control and Receiver System (Model SRSIR-001 / SRSIR-001FM/ SRSIR-001FMR) or equipment that is to be installed in conjunction with the system such as ®...
-
Page 3: Installation And Wiring Precautions
INSTALLATION and WIRING PRECAUTIONS To prevent a short-circuit, Be sure to turn off the ignition and remove the negative(-) battery cable, prior to installation. Connect power wires last. NOTE: If the SRSIR-001 / SRSIR-001FM/ SRSIR-001FMR System is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect the battery cable. -
Page 4: Packing List
PACKING LIST SRSIR-001 / SRSIR-001FM / SRSIR-001FMR (NOTE: Components are not drawn to scale.) MAIN SYSTEM COMPONENTS RADIO RECEIVER UNIT RADIO RECEIVER SATELLITE SYSTEM (RRU) SRSIR-001FM AND UNIT (RRU) SRSIR-001 CONTROL UNIT (SCU) SRSIR-001FMR P/N 144D2345 P/N 144D2346 P/N 144D2347 AUDIO OX AUDIO OX -or-... - Page 5 SRSIR-001FM AND SRSIR-001FMR RF MODULATED SYSTEM INSTALLATION...
- Page 7 TYPICAL FM MODULATED INSTALLATION for SRSIR-001FM SYSTEM COMPONENT LAYOUT...
-
Page 8: System Installation
SYSTEM INSTALLATION RADIO RECEIVER UNIT (RRU) PROCEDURE for HORIZONTAL INSTALLATION of the RRU Attach the mounting brackets to each side of the RRU, using the 4 Phillips Round Head Screws (4mm x 8mm). Bracket Phillips Head Screws (4mm x 8mm) used in 4 places Determine the mounting location and drill 4x 1/8”... - Page 9 PROCEDURE for VERTICAL INSTALLATION of the RRU Attach a mounting bracket to each side of the RRU, using the 4 Phillips Round Head Screws (4mm x 8mm). Phillips Head Screws (4mm x 8mm) used in 4 places Bracket Determine the mounting location and drill 4 x 1/8” (4mm) mounting holes. WARNING Never mount the unit near the fuel tank.
- Page 10 PROCEDURE for the MOUNTING of the RRU UNDER THE REAR DECK Attach the mounting brackets to each side of the RRU, using the 4 Phillips Round Head Screws (4mm x 8mm). Bracket Phillips Head Screws used in 4 places (4mm x 8mm) Determine the mounting location and drill four 4mm mounting holes.
- Page 11 INSTALLING THE SATELLITE SYSTEM CONTROL UNIT (SCU) PROCEDURE for a TYPICAL INSTALLATION of the SCU USING HOOK & LOOP ADHESIVE TAPE (SUPPLIED) 1. Determine where the SCU is to be located (flat surface) NOTE: The chosen position must allow a clear view of the display and easy access to the controls for both the Driver and Passenger of the vehicle.
- Page 12 PROCEDURE FOR A TYPICAL BRACKET INSTALLATION OF THE SCU (Bracket not supplied) Audiovox suggests this type of installation over the Hook & Loop type of installation though the Hook & Loop installation (if done correctly) is a secure and sufficient mounting option. Installation of the SCU using a bracket results in a professional, factory-installed look, without visibly damaging the interior of the vehicle.