Troubleshooting - Nespresso CITIZ&MILK Manual

TROUBLESHOOTING

EN
➔ Check the mains, plug, voltage, and fuse. In case of problems, call the
No light indicator.
Nespresso Club.
➔ First use: fill water tank with warm water (max. 55° C) and run through machine
according to instructions on page 10.
No coffee, no water.
➔ Water tank is empty. Fill water tank.
➔ Descale if necessary; see Descaling section.
➔ Flow speed depends on the coffee variety.
Coffee comes out very slowly.
➔ Descale if necessary; see Descaling section.
➔ Preheat cup.
Coffee is not hot enough.
➔ Descale if necessary.
Capsule area is leaking
➔ Position capsule correctly. If leakages occur, call the Nespresso Club.
(water in capsule container).
Irregular blinking. ➔ Send the appliance for repair - Contact the Nespresso Club.
No coffee, just water runs out
➔ In case of problems, call the Nespresso Club.
(despite inserted capsule).
➔ Be sure to position the jug correctly on a clean base. Be sure to attach the whisk
The jug does not start.
to the jug
➔ Be sure to use whole or semi-skimmed milk at refrigerated temperature (about
4-6° C).
Quality of milk froth not up to
➔ Be sure to use the appropriate whisk and the jug is clean
standard.
➔ It is highly recommended to not use special enriched milks, powdered reconsti-
tuted milks nor flavoured milks.
➔ a) The appliance is too hot. Rinse it under cool water b) Whisk is missing c) Not
Red Button blinking.
enough milk. Fill milk frother up to one of the two «max» level.
➔ Be sure to use the appropriate whisk and check the corresponding indicator
Milk Overflows.
level.
18
9579_UM_CITIZ&MILK_FACELIFT_C_BREVILLE.indb 18
8.
correctly.
30.03.16 15:22