Control Module & Component Mounting; Led And Valet Programming Button - CrimeStopper CS-872 Installation Instructions Manual

CONTROL MODULE & COMPONENT MOUNTING
DO NOT Mount the control module in the engine compartment or where the wiring harness can
become entangled with moving parts such as brake/gas/clutch pedals, or the steering column! The
alarm control module should be mounted in a concealed location. The Placement of the module will affect the
distance from which the remote transmitter can control the unit. The antenna wire should be routed away from
any metal if possible. Do not alter the length of the antenna wire or route it with other wires. Do not ground
the antenna wire. Fasten the module to a bracket or wire harness using the cable ties provided. Under dash
Mounting: If you are locating the control unit underdash, mount it as high as possible, not easily located by an
intruder. Driver's Side Under dash mounting provides an easy location for wiring most of the system's
connections; however this is a common location for an intruder to check for an alarm after breaking into the
vehicle.
SIREN: Mount the siren under the hood to an inner fender-well, wheel-well, or other body surface with the
open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the
sirens black wire to metal near the siren or you can use one of the siren's mounting screws for a ground.
LED: 2 PIN PLUG
Mount the blue LED in a visible location on the dashboard or console. The LED is used as a VALET /
PROGRAMMING indicator and it will also FLASH for use as security deterrent when the system is Armed.
Valet / Programming Button: 2 PIN PLUG (REQUIRED FOR PROGRAMMING & LEARNING REMOTES)
This switch is used for programming features, transmitters, valet mode, and to override the optional starter
disable (if installed) in the event of a non-operating remote control. Mount the Valet/Override/Program push-
button in a hidden but accessible location. It is REQUIRED for emergency disarm, programming features and
entering or exiting Valet Mode.
VALET / PROGRAM SWITCH
STATUS LED
3