Transmitter Programming - CrimeStopper CS-872 Installation Instructions Manual

NOTE: All transmitters must be learned at the time of programming. This system can learn up to 4 remotes.
1. Turn key to the ON position and press program button 4 times.
2. After a short delay, the unit will flash the parking lights 4 times; Siren 4 times, Horn 4 times and status LED
will be on solid.
3. Press Lock button of the first transmitter. You should get 1 chirp / light flash confirming the remote is coded,
then press Lock button of a second transmitter, the unit will flash 2 times confirming the remote is coded
and so on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key
off.
OFF
PRESS LOCK
2 VEHICLE OPERATION and PROGRAMMING: To set up the 2 vehicle operation you must have all 4
remotes for programming. For the first vehicle (remotes 1 & 2) press the Lock as in step 1 thru 3. To change
from vehicle 1 to vehicle 2, press the VEH button on remote for about 2 seconds. The LED on remote will
change from green to red.

TRANSMITTER PROGRAMMING

IGN
PRESS 4X's
FLASH 2, 3, or 4 X's
WAIT FOR
4 FLASHES
OFF
10
IGN
COMPLETE