Troubleshooting - Icom IC-GM1600 Instruction Manual

PROBLEM
The transceiver does • The battery is exhausted.
not turn ON.
• The Battery pack is not correctly attached.
N o s o u n d f r o m t h e • Squelch level is set too high.
speaker. • Volume level is set too low.
• The speaker has been exposed to water.
• Water has entered to the [MIC/SP] connector.
You cannot transmit, • Some channels are limited to low power,
or select high power. or for only receive.
• The battery is exhausted.
• The output power is set to low.
The displayed channel • Lock function is activated.
cannot be changed.
No beeps sound. • Beep tone is set to OFF.
Self check error. • The temperature is outside of –35°C to
(Temperature) +80°C, –31°F to +173°F (approximately).
Self check error. • The connected battery pack's voltage is
(Battery voltage) more than 11 V.

TROUBLESHOOTING

POSSIBLE CAUSE SOLUTION
• Change to a new battery pack (Survival).
• Recharge the battery pack (On-board).
• Correctly attach the battery pack.
• Set the squelch to the threshold point.
• Set the volume to a suitable level.
• Remove the water from the speaker.
• Dry the [MIC/SP] connector.
• Change channels.
• Change to a new battery pack (Survival).
• Recharge the battery pack (On-board).
• Push [Hi/Lo• ] to select high power.
• Push [Hi/Lo• ] for 1 second to cancel
the function.
• Set the beep tone to ON (Fix Beep/User
Beep) in the SET mode.
• Leave the transceiver at room temperature
for a while. Turn the power ON to check if the
internal temperature has returned to normal.
• Verify that the battery voltage is correct.
10
REF�
p. 16
pp. 17, 18
p. 3
p. 9
p. 8
—
—
pp. 8, 20
p. 16
pp. 17, 18
9
10
p. 8
p. 10
p. 12
—
—
21