Programming The Heating Mode - Sundance Spas Maxxus Owner's Manual

12.1

Programming the Heating Mode

Your Sundance spa is equipped with 3 modes of heating, Figure
12.1a. An automatic mode called "Auto" where the spa's temperature
is maintained at all times. An energy saving heating cycle called
"Economy." A mode that will only activate the heater during the daytime
called "Day" mode.
Note: The heater will activate when the temperature drops 2° from the
set temperature.
A
A
From the Settings Menu, tap
menu tab. Tap
heating settings.
A. Auto heating:
1. When programmed to "Auto," the spa will
maintain the water temperature to the
set temperature. Heating will occur when
necessary.
2. To select this mode, tap the "Auto" tab.
B. Economy heating:
1. This is an energy saving heating program that allows
the spa to heat during non-peak hours. When programmed to
"Economy," the spa will only be allowed to heat the water between
5:00 PM to 7:00 AM every day of the week. The hours cannot be
adjusted.
2. To select this mode, tap the "Economy" tab.
C. Day heating:
1. When programmed to "Day," the spa will only be allowed to heat the
water between 7:00 AM to 5:00 PM every day of the week. The hours
cannot be adjusted.
2. To select this mode, tap the "Day" tab.
SETTINGS
Information
Heat & Filter
Water Care
to the enter the menu. Then select one of the
Heat & Filter
A
A
Heat & Filter
Auto
Economy
Day
1
or to highlight the "Heat & Filter"
880 SERIES
Filter 2
A
A
Heat & Filter
Auto
Economy
Day
1 Filter
Figure 12.1a
Page 55
2