Change The Wireless Channel - Technicolor TG588v v2 Setup And User Manual

The TG588v v2 does not appear in your wireless client's access point list
• Make sure that the TG588v v2 wireless interface is enabled.
a Browse to the
For more information, see
b In the Wireless card header, make sure that the switch is
• If the signal is low or not available, try to reposition the TG588v v2 for optimal performance.
• Change the wireless
The TG588v v2 access point no longer available
If you were able to connect in the past, but can't connect anymore:
• Make sure that the wireless client adapter is enabled (message like "radio on").
• Make sure that the wireless client is still using the correct wireless settings (network name (SSID), security settings).
Poor Wireless Connectivity or Range
Try the following:
• Check the signal strength, indicated by the wireless client manager. If the signal is low, try to reposition the TG588v v2 for
optimal performance.
• Change the wireless
• Use WPA(2)-PSK as encryption.
For more information, see

Change the wireless channel

Proceed as follows:
1 Browse to the TG588v v2 web
For more information, see
2 Click Wireless. The Wireless page appears.
3 In the Channel list under Interface, click a channel other than displayed in Current channel.
4 Click Save.
DMS3-CTC-25-42 v1.0
TG588v v2 web interface.
"4.1.1 Accessing the TG588v v2 web interface from your local network" on page
channel.
channel.
"3.4 Securing your wireless connection" on page
interface.
"4.1.1 Accessing the TG588v v2 web interface from your local network" on page
.
24.
6 Support
29.
29.
54