6.4 Reset to factory defaults
Resetting your TG588v v2
If at some point you can no longer connect to the TG588v v2 or you want to make a fresh install, it may be useful to perform
a reset to factory defaults.
A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset a
reconfiguration of your TG588v v2 will be needed.
Also your wireless clients will have to be re-associated, as described in
Methods
You can choose between:
•
Resetting the TG588v v2 via the web interface
•
Reset the TG588v v2 via the Reset button
Resetting the TG588v v2 via the web interface
Proceed as follows:
1 Browse to the
TG588v v2 web
For more information, see
2 Click Gateway. The Gateway page appears.
3 Click Reset.
4 The TG588v v2 restores the factory default configuration and restarts.
Reset the TG588v v2 via the Reset button
Proceed as follows:
1 Make sure the TG588v v2 is turned on.
2 Push the Reset button for at least 7 seconds and then release it.
3 The TG588v v2 restarts.
Your system administrator may have disabled the physical reset button of the TG588v v2. In this case, a hardware
reset to defaults is not possible.
DMS3-CTC-25-42 v1.0
interface.
"4.1.1 Accessing the TG588v v2 web interface from your local network" on page
"3 Wireless networking" on page
Reset
6 Support
19.
29.
55