Replacing The Ctp Card - HP storageworks director 2/140 Service Manual

FRU Removal and Replacement
1
1
Figure 73: CTP card removal and replacement
6. Pull the CTP card from its card track and remove it from the director chassis.

Replacing the CTP Card

To replace a redundant CTP card:
1. Wait approximately 20 seconds after removal of the failed CTP card to begin
2. Remove the replacement card from its protective antistatic bag.
3. Hold the card by its stiffener and insert it in the chassis card track, as shown in
228
2
Torque tool
Place the card in an antistatic bag to provide ESD protection.
this replacement procedure.
Figure 73. The label identifying the card should be at the top. Verify the card
is aligned in the card tracks, then slide it forward until it makes contact with
the backplane.
CTP card
2
Director 2/140 Service Manual