Map 0400: Error Messages And Actions - HP storageworks director 2/140 Service Manual

Table 10
procedures.
Table 10: MAP 0400: Error Messages and Actions
Never connected.
Link timeout.
Protocol mismatch.
Duplicate session.
Unknown network address.
Incorrect product type.
8
Transmit or receive errors for a director's Ethernet adapter (on each CTP card)
exceeded a threshold, the director-to-HAFM appliance link was not connected, or
the director-to-HAFM appliance link timed out. A problem with the Ethernet
cable, Ethernet hub or hubs, or other LAN-attached device is indicated.
Verify the director is connected to the HAFM appliance through one or more
Ethernet hubs.
1. Ensure an RJ-45 Ethernet cable connects both of the director's CTP cards to
2. Ensure an RJ-45 Ethernet cable connects the HAFM appliance adapter card to
3. Ensure the Ethernet cables are not damaged. If damaged, replace the cables.
Was a corrective action performed?
NO
↓
9
Does the LAN configuration use multiple (up to four) Ethernet hubs that are
daisy-chained?
YES
↓
Director 2/140 Service Manual
lists the error messages and associated steps that describe fault isolation
Error Message
an Ethernet hub. If not, connect the cables as directed by the customer.
an Ethernet hub. If not, connect the cable as directed by the customer.
YES
Go to step 1.
NO
Go to step 11.
Action
Go to step 8
Go to step 8
Go to step 15
Go to step 18
Go to step 21
Go to step 23
Diagnostics
95